Live-Link Sr. "06X" Series General Specifications
Optical:
Cable: 2 single-mode fibers
Optical Budget: 14 dB minimum at 2.97 Gb/s; 17 dB minimum at 1.485 Gb/s
Transmission Distance: 10 km, minimum (per SMPTE® 297)
Wavelengths Utilized–Camera End to Control Room End:
SDI 1: 1310 nm
SDI 2: 1550 nm
Ethernet: 1490 nm
Wavelengths Utilized–Control Room End to Camera End:
SDI 1: 1310 nm
SDI 2: 1550 nm
Analog Video: 1530 nm
Ethernet: 1490 nm
Digital Video:
Number of Paths–Camera End to Control Room End: 2, SDI 1, SDI 2
Number of Paths–Control Room End to Camera End: 2, SDI 1, SDI 2
Data Rate: 3.0 Gb/s maximum
Supported Standards: 3G-SDI (SMPTE 424M), HD-SDI (SMPTE 292), SD-SDI (SMPTE 259M), DVB-ASI
Analog Video:
Number of Paths–Control Room End to Camera End: 1
Optical Transmission Method: analog
Mic/Line Audio:
Number of Channels: 4 (Camera End to Control Room End)
Frequency Response: 20 Hz to 20 kHz ±0.2 dB
Distortion: 0.1%, DC to 40 kHz
Signal-to-Noise Ratio: 84 dB, DC to 40 kHz
Dynamic Range: 104 dB
Line-Level Audio:
Number of Channels: 2 (Control Room End to Camera End)
Frequency Response: 20 Hz to 20 kHz ±0.1 dB
Distortion: 0.03%, DC to 40 kHz
Signal-to-Noise Ratio: 84 dB, DC to 40 kHz
Dynamic Range: 104 dB
2-Wire-to-4-Wire Interface:
Frequency Response: 100 Hz to 8 kHz ±2.5 dB
Distortion: 0.1%
Signal-To-Noise Ratio: 65 dB
Nulling Method: automatic upon user initiation; null settings stored in non-volatile memory
Nulling Cable Length Range: 0 to 3500 feet, typical
Data Transport:
RS-232, full duplex, asynchronous (serial)
RS-422, full duplex, asynchronous (serial)
Rate: auto-sensing, 115.2 kb/s, maximum with HD- or 3G-SDI (57.6 kb/s with SD-SDI)
GPI/GPO Transport:
GPI Input: +3.3 Vdc logic, activates on closure to system common
GPO Output: normally-open (form A) solid-state relay contact
Auxiliary Power Source: 12 Vdc nominal, 30 mA maximum
Live-Link Sr. "06X" Series Camera End Specifications
Optical Connector(s): Neutrik® opticalCON® DUO or two ST (UPC polish), factory installed, selectable at time of order
Digital Video Inputs: 2
Connector: BNC
Type: unbalanced
Impedance: 75 ohms
Digital Video Outputs: 2
Connector: BNC
Type: unbalanced
Impedance: 75 ohms
Level: 800 mV p-p
Analog Video Outputs: 1
Connector: BNC
Type: unbalanced
Impedance: 75 ohms
Level: 1 V p-p
Mic/Line Audio Inputs: 4
Connector: 3-pin female XLR
Type: electronically balanced
Impedance: 2 k ohms
Level: +24 dBu maximum including mic gain
Gain: 0 dB, 15 dB, 30 dB, 45 dB, selectable
Phantom Power: P48 (+48 Vdc nominal), selectable on/off
Non-Powered IFB Audio Outputs: 2
Connector: 3-pin male XLR
Type: electronically balanced
Impedance: 100 ohms
Level: +4 dBu nominal, +24 dBu maximum
Powered IFB Output: 1, 2-channel
Connector: 3-pin male XLR
Type: DC power with two channels of unbalanced audio ("wet" IFB)
Impedance: 200 ohms
Audio Level: –10 dBu nominal
Power Source: 28 Vdc nominal, 120 mA maximum
Party-Line (PL) Intercom Interface: 1, 2-channel
Connector: 3-pin male XLR
Type: 2-wire party-line (PL)
Impedance: 200 ohms
Audio Level: –10 dBu nominal
2-Wire Power Source: 28 Vdc nominal, 230 mA maximum
Compatibility: single- and dual-channel intercom systems such as those from RTS® and Clear-Com®
Ethernet:
Connector: RJ45 (auto MDI/MDI-X)
Rate: 10/100/1000 auto sensing
RS-232, RS-422, GPI, GPO, and Auxiliary Power Source:
Connector: 15-pin D-subminiature female (DA-15F)
Power:
DC Input Range: 10 to 18 V
Requirement: 30 watts maximum
DC Input Connector: 4-pin male XLR
Battery Mount: Anton/Bauer® Gold Mount System (V-Mount optional)
Dimensions (including protective bumpers and handle):
8.36 inches wide (21.2 cm)
6.54 inches high (16.6 cm)
13.33 inches deep (33.9 cm)
Weight: 10.9 pounds (5.0 kg)
Live-Link "06X" Series Control Room Specifications
Optical Connector(s): Neutrik® opticalCON® DUO or two ST (UPC polish), factory installed, selectable at time of order
Digital Video Inputs: 2
Connector: BNC
Type: unbalanced
Impedance: 75 ohms
Analog Video Inputs: 1
Connector: BNC
Type: unbalanced
Impedance: 75 ohms
Digital Video Outputs: 2
Connector: BNC
Type: unbalanced
Impedance: 75 ohms
Level: 800 mV p-p
Mic/Line Audio Outputs: 4
Connector: 3-pin male XLR
Type: electronically balanced
Impedance: 100 ohms
Level: +4 dBu nominal, +24 dBu maximum
Line-Level Audio Inputs: 2
Connector: 3-pin female XLR
Type: electronically balanced
Impedance: 10 k ohms
Level: +4 dBu nominal, +24 dBu maximum
4-Wire Intercom Version–Audio Inputs: 2
Connector: 3-pin female XLR
Type: electronically balanced
Impedance: 10 k ohms
Level: +4 dBu nominal, +24 dBu maximum
4-Wire Intercom Version–Audio Outputs: 2
Connector: 3-pin male XLR
Type: electronically balanced
Impedance: 100 ohms
Level: +4 dBu nominal, +24 dBu maximum
Party-Line (PL) Intercom Interface Version: 1, 2-channel
Connector: 3-pin male XLR
Type: 2-wire party-line (PL)
Audio Level: –10 dBu nominal
Power Source and Impedance: 28 Vdc nominal, 315 mA maximum, 200 ohms, selectable on/off
Compatibility: single- and dual-channel intercom systems such as those from RTS® and Clear-Com®
Ethernet:
Connector: RJ45 (auto MDI/MDI-X)
Rate: 10/100/1000 auto sensing
RS-232, RS-422, GPI, GPO, and Auxiliary Power Source:
Connector: 15-pin D-subminiature female (DA-15F)
Power:
DC Input Range: 10 to 18 V
Requirement: 20 watts maximum
DC Input Connector: 4-pin male XLR
Battery Mount: Anton/Bauer Gold Mount System (Portable Version only) (V-Mount optional)
Dimensions (Portable Version, including protective bumpers and handle):
8.36 inches wide (21.2 cm)
6.54 inches high (16.6 cm)
13.33 inches deep (33.9 cm)
Dimensions (Rack-Ready Version):
8.36 inches wide (21.2 cm)
5.00 inches high (12.7 cm)
12.60 inches deep (32.0 cm)
Weight:
Portable Versions: 10.9 pounds (5.0 kg)
Rack-Ready Versions: 7.7 pounds (3.5 kg)
Options and Accessories
Rack Mounting Enclosure: 3U, holds one or two Rack-Ready Control Room Units
See Price List for other options and accessories
Specifications and information subject to change without notice.
