|
The Model 35 Talent Amplifier
is a full-featured stereo headphone amplifier (cue) for use with the
StudioComm 55/56 Stereo Monitoring System or StudioComm 74/75 Surround
Monitoring System.
Overview
Model 35 modules are
typically deployed in voice-over booths, studio areas, or other
locations where voice or music talent needs access to a headphone
cue feed. Using a standard 3-pin XLR-type audio cable, the Model 35
connects directly to, and is powered by, a
StudioComm 55/56 or
StudioComm 74/75 system. The
Model 35 provides a stereo audio amplifier, built-in level control,
stereo/mono switch, and support for one or two pairs of headphones.
Up to four Model 35 Talent Amplifier modules can be used with a
StudioComm 55/56 or StudioComm 74/75 system.
Model 35
Specifications
Power Requirements:
+20-32 Vdc (modulated with left channel audio), provided by Model 55
or Model 74 Central Controller
Power Present LED:
red, indicates presence of operating power
Connectors:
Input (from Model 55 or Model 74): 3-pin XLR-type, female
Loop Thru: 3-pin XLR-type, male, connected in parallel with input
connector
Headphone Outputs: 2, ¼ -inch, 3-conductor (stereo) phone jacks
Headphone Output:
1, feeds two headphone jacks
Load: intended for
connection to one or two pairs of headphones with total impedance of
75 ohms or greater
Output Level: user
adjustable
Maximum Output Voltage:
16 V peak-to-peak into 150 ohms @ 1% THD+Noise, 400 Hz
Distortion (THD+N):
0.03%
Frequency Response:
20 Hz-20 kHz ±0.5 dB
Dimensions (Overall):
4.2 inches wide (10.7 cm)
2.0 inches high (5.1 cm)
5.3 inches deep (13.5 cm)
Mounting: desktop;
microphone stand mounting adapter included
Weight: 0.8 pounds
(0.4 kg)
Specifications
subject to change without notice.
|
